Ask Experts Questions for FREE Help !
Ask
    kasinokat's Avatar
    kasinokat Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 1, 2011, 04:42 AM
    I have a bryant gas furnace. About 10yrs old.
    Replaced motor blower 3 yrs ago. The pilot light is lit, the furnace is running but when I check the vents it is blowing out just barely warm air. I replaced filter and batteries in thermostat. What else can I do?
    SeattlePioneer's Avatar
    SeattlePioneer Posts: 97, Reputation: 9
    Junior Member
    		  
    #2

    Mar 2, 2011, 01:35 AM
    Take the cover off the burner compartment of the furnace. Find the model of the furnace on the rating plate of the furnace and post it here.


    Carefully observe the sequence of events that occur when you turn the thermostat up and describe them here.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant Plus 80 two speed gas furnace [ 0 Answers ]

I am having a problem where the "gas jets" are not firing all the way through... meaning the first one with the glow igniter fires and the second "jet" fires immediately, but the flame does not continue to fire the third and fourth "jets" which does not put a flame on the sensor located at the...

Bryant 80 Gas Furnace error 24 [ 0 Answers ]

I was moving our thermostat, now heater is not working, LED blinks 2 times slow 4 times fast, panel says it's an open circuit at the 24 volt fuse, or a short. Could I have blown the fuse moving the thermostat? If so where is it located ? I'd like to try and do this myself,Being Thanksgiving, where...

Bryant 383k gas furnace [ 1 Answers ]

Our Bryant 383K Gas Furnace starts and runs for few seconds and goes off. Than it starts again and the cycle continues. What is the problem and how can I correct it? E.R.

Bryant gas furnace [ 1 Answers ]

I have a bryant gas furnace model 383kav038070. I get trouble shooting code 12. What has failed. I do not have code table

Bryant gas furnace won't light [ 1 Answers ]

I have a Bryant gas furnace that won't light. It starts its normal cycle with the inducer turning on, then the gas but the gas never ignites. It will do this three times then stops.

View more questions Search