Ask Experts Questions for FREE Help !
Ask
    RAYSID's Avatar
    RAYSID Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Feb 27, 2011, 12:27 PM
    Ruud silhouette cycles after 2 min
    Ruud silhouette ugug07namgr shuts off before call for heat ends. The amtek windjammer housing gets very hot yet the limit switch on it still has continuity through it. The burners burn for approx 90 to 120 secs. And the trace odor of gas is present immediately after the burners stop. During this time the fans are still running. After approx. 4 to 5 min. The process of firing up begins again.
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Feb 27, 2011, 06:57 PM
    Odor of gas, burners not burning? Sound like you have dirty burners. Smelling the odor of gas takes the dirty flame sensor out of the equation. Clean the burners and see how it works.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ruud silhouette ii only stop for few seconds? [ 0 Answers ]

I have a ruud silhouette II that is around 5 years old and we have the thermostat set at 72 but house will only get to about 68. The heater will run for 15 minutes and then shut off for about 30 seconds and fire back up again. I know my pressure sensor is starting to go bad.once in a while I have...

The gas comes on lights... And 4-6 seconds it turns off. Ruud Silhouette [ 4 Answers ]

I have a Rudd Silhouette model UGDG-07EAUER Serial # CW5O30Z F0194 4182 - The control board appeared burned and the Gas would not come on. I replaced the control board (honeywell) S9201A with a UT Board 62-24084-82 The draft motor comes one, The ignitor glows, The gas comes on and lights... and...

RUUD Silhouette II intermittent running, ineffective. [ 1 Answers ]

Dang thing won't stay heating. Sometimes will respond perfectly to set-back thermostat for weeks. Then has to be hit in the area of insignia, area of the draft inducer, before flame will start and fan start. The hitting involves significant trek outside, cold outside and inside. This has been...

RUUD Silhouette Furnace/AC UNit Burning up 24v transformers [ 1 Answers ]

I have a 10 yr old Ruud unit that has blown (2) 24vac 40va transformers. Can Anyone tell me what might be causing it. The first one was the original, the second one didn't last the night. Help Please. Thanks

View more questions Search