 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
The power vent has a temperature sensor that starts the blower. Some units use and anticipator that starts the blower prior to firing the gas flame. This is what is failing on your blower. Blowers are not difficult to replace and may be cheaper than paying someone to fix your current blower. Check the internet and plumbing supply houses for a better price.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
After installing a new starter on a 1999 2WD Explorer it will not start. There is no click when trying to start it, its just dead, and the radio, power locks/windows, a/c, and dash light don't work but the interior lights work and so do the headlights. We've had the starter checked to make sure...
I have a Laundry Tray Pump System connected to my wash tub in my fifteen year old townhome's basement. I was recently informed that it was not properly installed because I never connected the vent pipe from the pump. I had some one look at it and was told that the house's vent system (which...
The schematic below should make it clear the configuration I would like to use. Basically, I would like to keep the vent under the floor for a little ways, so it pops up in a better location. I cannot easily move the 2" drain location going down and would rather not go straight up from the...
Hello, I am building a garage and plan on putting in a hot water tank. Since it's a garage I wanted to get the direct vent type to get the air from outisde the garage. Question is, Can I use a non powered direct vent hot water tank with vinyl siding on the outside of my garage? I didn't want...
You mention many times that you can wet vent your shower by attaching it to your vented lav drain. Are there any problems doing it the other way around, venting your lav by attaching it to your vented shower drain?
View more questions Search
|
