Furnace cycles on & off but very little heat

Eskilover Posts: 1, Reputation: 1

New Member

Feb 23, 2011, 06:55 PM

Furnace cycles on & off but very little heat

The fan comes on, then it cycles down, I can hear the pilot light click, then the roar of the furnace as it starts to light, then a loud click & the whole thing starts over again

Check out some similar questions!

Furnace Gives Heat but Cycles Frequently [ 16 Answers ]

OK, Labman and others proved very helpful in the past with my ignitor problem so now I have another question: How long should a proper furnace run between cycles? I have read about the flame sensors and "limit switches" but I'm not sure if this is related to either. My heater seems to go...

Heater cycles too short and cycles many times before heat actually goes on... [ 0 Answers ]

I have a 4 year old Goodman heater model GMS81155CNA that we just replaced the blower motor on, fortunately it was under warranty until April. Now it keeps trying to cycle 2 or 3 times before the burners actually go on, sometimes it will ignite on the first attempt other times it won't. Often we...

Bryant furnace fan cycles on 1 or 2 times for 2 or 3 sec. After heat cycle has ended [ 8 Answers ]

I have a Bryant furnace Mod. #394GAD024050 and after the temp has reached the set point and the furnace has cycled off the fan will come back on a couple of times for approx. 2 or 3 seconds. In the older furnaces with a machanical fan/limit switch some times the temp would creep up and cause the...

Furnace heat cycles on/off [ 1 Answers ]

We have an old furnace,not quite sure how old.It is a Bryant Quietair.I noticed tonight the burners would light,stay lit for a few seconds(30-40secs.),then go out,and then relight a few seconds later.The fan is running throughout the whole process like it should.This goes on constantly.What is...

View more questions Search

Check out some similar questions!

Add your answer here.