 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
While I have never worked on a Dyson, in every other brand, a non turning brush is almost always a broken drive belt. Unplug the vac, turn it over, look for a plate where the air is sucked in and the brush is located. There should be 2-4 screws. Remove the screws and the plate and you should see the roller brush and most likely a broken belt. Go to a vac store with the model# and get 2 belts. You have to slide the roller out, put the belt on. The roller is usually set in a groove to keep the bearing plate from turning. Push the roller back in and put the plate back. Hope this works.
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have a Dyson DC07. It won't pick anything up although the motor is working okay. I have cleared all the obvious areas and have washed the filter. Although after clearing these areas, it will pick up with very weak suction for a few minutes using the attachment, it then stops and I end up...
My dyson assembly bin doesn't work. I press the release button and it's completely stuck. It's full right now so I don't want to use it anymore. Any suggestions my carpet is in dire need of a vacuum.
Having a problem with getting it click into it's upright position, this has only just happened and it's been fine for the last 5 years. Since this happened the direction of suction is only through the wand (I would call it the handle but that's what it's called in the manual). I can't see...
Hi, my dyson dc07 won't pick up properly, it seems the air doesn't circulate in the cylinder anymore and when you take the cylinder off to empty what little it did manage to lift the bottom of the cylinder is very hot. Can anyone tell me what I need to do to fix this problem.
View more questions Search
|
