 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Status light out on a 31m73 Air control board
I had a blown F7 fuze on my 31m73 (B24-P series), replaced the fuze, still got nothing, and the status light has no blinky-flashy. Judging by the diagram, I think it is the blower relay, but I am not sure how to confirm my problem. Does any know the best route to take with a dark status light, before I go and spend another large amount on a circuit card?
|
||||
Check out some similar questions!
I have a goodman Board number 1012-930 or B18099-05 The status light is off and the machine will not do anything. I have 24 AC going to the board when the door switch is made. Is there a print of the board or does the status light off mean its dead?
My furnace runs for a while then the flame goes out but the blower keeps running. Control board has solid red light that means internal control board failure (replace)I turn off the power to the unit and then turn back on, it runs for a while then repeats. Seems to get worse the colder it is outside
Panel control board
The Remote Climate Control (RCC) module is capable of displaying both self-test faults and intermittent (run time) faults on the Integrated Control Panel (ICP). To obtain these codes, perform the following EATC on-board diagnostics test: . On-board diagnostics should be run in ambient...
I am replacing my old burnt 18k201 circuit board with the new 31m73 on my Lennox air handler and have run into a problem with the wiring. The exiting wiring harness is a 14 pin P2 connector and the new one has a 10 pin J85. Is there an adapter available to mate the 2 or at least some intructions on...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
