 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
My kenmor 90 series dryer won't start
When I press the start button I hear a low buzzing sound,but nothing happens, I removed the front panel under the door to look at the thermol fuse and it is OK I can see where the thermostat is at and it turn bright red and heats up but still my dryer won't turn on
Model number 96591220 |
||||
|
||||
|
That is not your thermostat, its your heating element. You can't tell if a dryer fuse is good by looking at it but since your element is heating it is likely good. Now we need to look at the motor that spins the drum. May take another person to safely do this. Put test leads on the 2 wires going to the motor, not the green wire, it's a ground. When you push the start button can you confirm power to the motor? |
||||
Not your question?
Ask your question
View similar questions
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have A Kenmor 80 series Dryer about 5 yrs old losess flaim about 6 min into cycle I
[ 1 Answers ]
I have A Kenmor 80 series Dryer about 5 yrs old losess flam about 6 min into cycle ignitor attemps to relight but dose not
Kenmore 80 series gas dryer won't heat
[ 1 Answers ]
How can I find out for sure what part I need to replace for my dryer? Model number 11074832400. I cannot find the manual either, is there someplace I can see a manual on line for free?
Kenmore he4 panel won't work and dryer won't start
[ 1 Answers ]
I have had the circuit board/panel replaced once on my he4. I had only 2 weeks left on the warranty and figured it should be OK once it was fixed. They wanted another $200 to renew the warranty! Didn't have the $$ at the time. Anyway, the same darn thing is happening... you have to push the buttons...
View more questions Search
|
