 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Trane XR80 - How to clean gas orifices
My Trane XR80, horizontal, upflow, propane hot air furnacehas a yellow, feathery flame on the lowest burner. This also causes a back draft (roll out?) on that burner with the door in place. With the door off it burns just fine, I had it burning for half an hour this afternoon. How do I clean the orifice, just with a cloth or Q-tip in place, or should I remove the burner assembly? Does this yellow, feathery flame indicate a perforated heat exchanger? Thanks in advance for any help,
Tony |
||||
Check out some similar questions!
My xr80 furnace, when the fan is in the auto position, will not stay lit. it flames up for ten to fifty seconds but will not stay lit. when I turn the fan to the on position, it flames up and stays lit. I cleaned the furnace and filter. What could it be? What else can I do?
We have a Trane XR80, 12 Seer rating furnace. We are experiencing excess condensation (pools of water on the floor and walls). What do we do to correct this?
My Trane XR80 furnace is only blowing cold air. The diagnostic light is bllinking 4 times. I checked diagnostic codes and this one means (open limit device). Please clarify which part(device) needs to be replaced?
Woke up to a smell of electric smoke... furnace (gas) on, but not blowing warmth into the house. I did a few things and this is what happened: 1. Heater on, fan on auto, no flow of air, the igniter wouldn't work either, smell of elictrical burn-out 2. Heater on, fan on, no flow of air, igniter...
My tenant is trying to turn the furnace on for the first time this fall. She can get the blower to blow out cold air, but not hot. I told her to turn the (digital) thermostat to "off" and to leave it off for a bit. Then to turn it to "heat". She says when she does that it just blows out cold...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
