Wiring 6 pot lights with 2 plugs

usanadon Posts: 1, Reputation: 1

New Member

Jan 13, 2011, 03:39 PM

Wiring 6 pot lights with 2 plugs

Have 14-2 wire from panel to switch box heading off to si pot lights and 2 plug boxes all of 14-2 wire how do I tie all these wires together in the box?

hkstroud Posts: 11,929, Reputation: 899

Home Improvement & Construction Expert

Jan 13, 2011, 05:47 PM

Attached Images

Add your answer here.

Check out some similar questions!

Can I have 21 recepticals, 10 lights, 3 fans, and 3 (240v) plugs on 100 amp breaker? [ 4 Answers ]

I just bought a 100 amp breaker panel to replace an old fuse panel. The thing is, after I figured up everything I wanted in the shop, (21 receps. 10 lights, 8 switches{4-3way switches and 4-single}, 3 fans{2 w/ lights}, and 3-(240v)plugs), I'm now not sure if I can pull all them on a 100 amp...

Going from a ceiling fan to pot lights [ 2 Answers ]

Going from red black and white wires to just black and white how do I hook up my pot lights . Thanks

98 Civic lights pulsing after replacing ignition coil and plugs/ wires [ 3 Answers ]

1998 Honda Civic EX coupe, 222K miles, original owner, timing belts/ water pumps changed every 100K Car just stopped while driving Sunday, we did some research and decided to replace the ignition coil... my brother is mechanically inclined but not familiar with Hondas. So he replaced it, and...

Pot lights [ 5 Answers ]

If I buy pot light from the U.S are they CSA Approved and can the be installed in Canada George

Selection of pot lights for good lighting [ 2 Answers ]

I am building a rec room in my basement. The room is 13 feet by 20 feet, with a 7 foot high ceiling. I will have a TV, piano, couch, easy chair, end table, coffee table, etc, in the room. In order to save headroom, I am thinking I should install recessed pot lights, perhaps two rows of 4. I...