Ask Experts Questions for FREE Help !
Ask
    RDBBAKER's Avatar
    RDBBAKER Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 11, 2011, 06:07 PM
    My trane xe80 is showing code 4
    Thermal protection device is open. We tried resetting the switch and the power its getting awful cold in here any help would be appreciated

Check out some similar questions!

Trane xe80 4 flash error code [ 1 Answers ]

My 8 year old Trane XE80 heat comes on then when it cycles off the fan keeps running and I get 4 flash error code. Help please. Thanks

TRANE XE80. Problem Code: 1 long and 4 short blinking lights [ 0 Answers ]

One morning about a month ago, my furnace wouldn't start. The repairman came and replaced the "inducer draft motor and blower assembly". Not cheap! At that time I didn't know enough to record the blinking light code, but looking back I think it was blinking 3 times. Now, a month later, at 6 am...

Trane XE80 furnace occasionally produces no heat, error code 4 [ 3 Answers ]

Hello, I have a Trane XE80, model number TDD080C936E0. A few weeks ago, it started blowing only cold air with error code 4 - high temperature limit open. If I shut it down, and start it up again in about an hour or so, sometimes it comes back on, sometimes it doesn't (produce cold air only). ...

Trane xe80 code 4, no heat [ 5 Answers ]

All summer the cooling worked fine, when I switch over to heat this week, it didn't come on. The control box shows a code 4, which says "THERMAL PROTECTION DEVICE OPEN" Any help?

Trane XE80 blows cold error code 22 [ 5 Answers ]

From my earlier post ignite for a few seconds the stops, now, heat commanded, blower motor runs, no ignition, and flashes code 22 Help!

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.