 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
I have bypassed the limit switch and roll out switches and that is not the problem. Could it be the flame sensor or circuit board?
Inducer motor runs, flame lights for a few seconds, goes off. Tries 3 times then turns off. Signals with 1 blink. So far, flame sensor has been cleaned, safety switches tested, Inducer motor safety switch has been jumpered out. Nothing changes.
I have a 5 year old Goodman PGB024075-1A gas furnace. The LED is flashing a "2" error code, meaning an open end switch. I'm attempting to track down the potential causes of this error. After taking things apart, I found and removed an insect nest (the dirt clog kind) which had found its way into...
Indicates a open limit switch Here some info I'm installing a used funace,, I've had it checked out by a certified guy And we had it running while we checked it out... worked great... Then I installed it in my house,, when I hooked it up and turned it on The inducer comes on, and the main...
Furnace shuts off when tube fills 2-3", then I unplught the drain tube where it is attached to a round bowl, (whats the name of this thing), the round bowl, has a pvc drain pipe leading away. This pvc drain tube is open as it runs down the side of the furnace and stops. Directly below is a pvc...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
