 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Does 18 year old york stellar home furnace post some error code
Burner shuts off before set temp is reached. Blower continues to run and igniter comes on to light gas but before gas turns on blower stops. Gas then turns on and lights but when blower comes back on, flames dances and will repeatedly shoot flame out of heat exchanger. If the gas valve and burners do not shut off and continue to burn until set temp is reached, burner flame is steady and no flame shoots out of heat exchanger. Is there an error code posted and where can I find it?
|
||||
Check out some similar questions!
York diamond 80 furnace 12 year old White Rogers controller Model 50A50 241 displays error code 8 1. I cleaned flame sensor - no change 2. I replaced flame sensor with new on - controller still displays error code 8 Is it time to replace controller board?
York diamond 90 furnace in lock down error code 1? Blower on no heat
Hi, I have a 6 year old york furnace that doesn't seem to be working anymore. The burner turns on for 20 sec each time up to 3 times then goes out. I took out the ignition sensor and cleaned but doesn't seem to work. When I look at the error code, it gives me 6 flash lights. Any Help would be...
The inducer motor was running but now flame reset control board furnace fired up about 5 times then locked out on reverse poliarity code yellow flashing checked high voltage poliarity coming into the furnace was fine but having intermiten problems any suggestions
My York Stellar heat pump runs for some time normally. Then the thermostat light starts blinking 4 times (error code 4). However, the discharge line gets normally hot. It will work OK again for a time after I reset the error code. Thanks for the help PJ
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
