Ask Experts Questions for FREE Help !
Ask
    Silverangel0506's Avatar
    Silverangel0506 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 4, 2011, 03:04 AM
    PLEASE HELP 91 Honda won't start?
    Hey guys I have a 91 Honda it was down for a bit I replaced the fuses. And the battery! The car worked again. But one night it just stopped right there in the middle of the street. No signs nothing just died out. Not it won't start. It tries to it sounds like it wants to. But it won't! Please help I'm out of a car and want my Honda back! Thanks!
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Jan 4, 2011, 06:54 AM

    If the CEL comes on and goes off after 2 seconds, when the ignition switch is turned to ON (Posiiton II), then replace the Ignition Control Module (ICM) and coil:

    https://www.askmehelpdesk.com/cars-t...tml#post265896
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1989 honda civic sometimes start sometimes don't start [ 1 Answers ]

I have 1989 honda civic some times don't start but it happen with in three days at night it cannot statr but in the morning it starts but I did not change anything yet can any body help me please

My honda accor d don't start,I'm put other distributor , only make sound like start [ 1 Answers ]

I change the distributor, but doing samething, make sound like start ,(the starter so weird)

My 1995 Honda Civic will not start. It will not jump start. [ 4 Answers ]

I can push it and it will start. The lights work. Autozone said the starter is fine. Please help TY.

1994 honda civic will roll start but won't start with a key [ 1 Answers ]

Repalced distributer cap, plugs and wires, and coil, car will roll start but still won't start with a key

91 honda crx no start or rough start, puzzled HELP! [ 5 Answers ]

Ok, I'm running a SOHC ZC motor. I have good compressions across all pistons at 135psi and holding a piece. I have checked the timing and it is correct. I have checked the fuel pressure and it is OK. I haven't been able to figure out how to lean the fuel out though, but anyway, it starts up and...

View more questions Search