 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Diagnostic ights indicate two flashing green - no heat and it is 32 outside... Yikes!
Hi Guys
I have a Rheem Criterion ii Furnace and the diagnostic ights indicate two flashing green. The troubleshooting guide says that this is a pressure switch problem. Is there a way that I can confirm the problem? Can I bypass the switch until I can get the new part installed. |
||||
Check out some similar questions!
Bryant gas furnace 14 yrs old flashing 31 on diagnostic led
To be clear, the furnace maintains the heating cycle until the target temperature is reached. Once it kicks off, it stays off until I go to the basement to reset it. It will not come on automatically once the temperature falls below the target setting. With these cold temperatures and a target...
Any ideas what's wrong it's a coleman mobile home furnace
In January 2006 I had a new furnace installed ( a coleman gas furnace Model # BGAA070BDTBJ) and this ran fine throughout the rest of that winter. Early in the summer our thermostat went out and I installed a new Hunter thermostat # 42999 and I hooked it up as shown in the directions and it worked...
I'm replacing an older Honeywell thermostat with a new programmable Noma/UPM model THM501. There are 4 wires - red, yellow, white and blue. On the Honeywell the blue wire was on the "G" terminal - all worked well. I wired up the new one the same way. However, although the new thermostat shows the...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
