Ask Experts Questions for FREE Help !
Ask
    jericjj's Avatar
    jericjj Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 20, 2010, 10:22 AM
    Lennox G51MP is not maintaining heat cycle. DS1: off DS2: flashing green
    To be clear, the furnace maintains the heating cycle until the target temperature is reached. Once it kicks off, it stays off until I go to the basement to reset it. It will not come on automatically once the temperature falls below the target setting. With these cold temperatures and a target heat of 70, we go to bed with everything working fine and wake up to to 50+ degree temperatures in the new addition. We have temporarily bypassed this problem by setting the target heat higher to 73 degrees. The system has difficulty warming to the higher temp and hence stays running through the night. These appear to be the same symptoms from our last repair of the pressure switch. I understand something else may be causing it, but we have to consider the pressure switch may not be playing nice in the sandbox or potential problem with the circuit board.

Check out some similar questions!

LENNOX Gas Furnace-High Efficiency G51MP Series NO HOT AIR [ 9 Answers ]

My LENNOX Gas Furnace-High Efficiency G51MP Series is 2 years old. The furnace used to work perfectly. 4 Days ago I started having a problem with it. We woke up in the middle of the night and the house is very cold. The thermostat is set to 72°F and it was reading 66°F. The furnace was running but...

Trouble maintaining heat [ 1 Answers ]

Heat will not maintain thermostat temp I changed the batteries in the thermostat and the heat only reach 65 degrees I have it set on 70

Flashing green light on dash [ 1 Answers ]

There is a flashing green light on the right side of the dash on my daughter's 91 honda car What does it means?


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.