Ask Experts Questions for FREE Help !
Ask
    MisterFixersays's Avatar
    MisterFixersays Posts: 2, Reputation: 1
    New Member
     
    #1

    Dec 18, 2010, 02:41 PM
    Reconnecting ceiling fixture - configuration?
    When I took out the old fixture, I neglected to note the configuration (small mistake, big headaches!). Unlike all other configs in the condo, this one has: on one side - black, red, white and ground; on the other side, black, white and ground. Both grounds are connected to the box. I've tried a zillion combinations but none of them work. Any hints out there?
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
     
    #2

    Dec 19, 2010, 05:40 AM

    Are there two switches, or more, that control this light?
    MisterFixersays's Avatar
    MisterFixersays Posts: 2, Reputation: 1
    New Member
     
    #3

    Dec 19, 2010, 08:50 AM
    There's only one - however, I've solved the problem: First, thanks to a comment I found on another site, I replaced my switch, which as suggested, I had blown during one of my tests. Second, I then went back to the basic solution recommended by several others - all white, all black + red together. Finally, I used only one black and white, instead of the two of each (which I think is what you were getting to). This did the trick.
    Anyway, thanks for the response, TK - much appreciated.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring my ceiling Fixture [ 1 Answers ]

The ceilng electrical box that I'm trying to connect a fixture to has three - two wire 14 ga. And one three wire 14 ga. Present (total of 4). All black wires are tied together and all white wires are connected to one another. The only wire bare on it's own is the red wire. Can you advise on how to...

Installation of ceiling fixture [ 2 Answers ]

I purchased a ceiling fixture and my son installed it. It has 2 white wires and two black wires which he connected to the white and black one in the ceiling but the light does not turn off from the wall switch. The ceiling wiring also has a red wire which I do not know what to connect that to or...

Wiring ceiling fixture [ 9 Answers ]

Hi... I have replaced ceiling light fixtures before, and always observed which wires were connected to which. My problem is, my son moved out and took his bedroom ceiling fixture with him, so now I don't know how the wires should connect to the new fixture. My house was built around 1950-1955. ...

Adding second ceiling fixture [ 1 Answers ]

My kitchen has 1 fluorescent ceiling fixture and I want to replace it with 2 chandeliers. How do I add the 2nd box for the new light? ( it's 3 feet away from the existing box)

Ceiling fixture [ 1 Answers ]

I have a light switch that controls the electrical sockets in the wall. I had an existing electrical box in the ceiling and I put a light up but it would not work. So I put up a ceiling fan thinking it would work because of the pull string. Well nothing is working and I don't know what I should...


View more questions Search