Ask Experts Questions for FREE Help !
Ask
    prtsider's Avatar
    prtsider Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 16, 2010, 02:24 PM
    Lennox elite series oil furnace.. . runs once then pops reset
    Clean fuel,full tank,new filter, bled air,new nozzle.Furnace burns fine for one cycle(3 minutes.)then pops reset when starting next time.. I have to wait 2 hours before I can run it again... if I try within 10-15 minutes reset stays down but I don't see spark or flame in view window? Ignitor problem? Help?
    Covertaire's Avatar
    Covertaire Posts: 13, Reputation: 2
    New Member
    		  
    #2

    Dec 17, 2010, 03:48 PM
    Check 3 things. One is the cad cell located under the transformer, second check the transformer, also check to make sure there's no black goo coming out the transformer as that's not good, then finally check your porcelains. Your problem should lie right there...
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Lennox furnace elite series [ 4 Answers ]

Problem with Lennox Elite Series... Burners will start but blower motor will not... can you cast any light on the subject... Thanks signed... Cold Chicagoan

Lennox Elite thermostat locked out, how do I reset it? [ 0 Answers ]

My Lennox Elite Series Programmable thermostat seems tobe locked out. I can not change settings. It does run the program. I cannot access the setup system. Help

I have a lennox outside a/c unit and a lennox g26 series furnace.Low hum no air/ht [ 4 Answers ]

Lennox Value Series... serial 5896G56798 M/N 10ACB365-5 P Central a/c unit and a Lennox G26 Series gas furnace both about 13 or 14 yrs old. Came home from vacation and turned A/C on (son tried earlier in the week) only a low hum whether on auto or fan or if we try heat(same thing, low hum)......

I have a Lennox elite series furnace. The vents are just blow out cold air, not heat. [ 1 Answers ]

I have a Lennox elite series furnace. The vents are just blow out cold air, not heat. The theromstat is now working strange. I set the digital theromstat at 75 deg. And then place the thermostat on hold. The temp. emediately goes to 65 deg. I went into the attic and looked at the system. I read...

Lennox elite series gas furnace [ 0 Answers ]

I set the thermostat at 70 degrees,the house is currently 63 degrees... the heater comes on, I see the flame and hear the blower,but it will only work for 2 minutes at a time.I cahnged the battries in theHoneywell electric thermostat but there was no change. Is there a way to troubleshoot(other...

View more questions Search