Lennox G51MP burners will not ingnite?

alars75 Posts: 1, Reputation: 1

New Member

Dec 12, 2010, 03:04 AM

Lennox G51MP burners will not ingnite?

My Lennox G51MP burners will not ingnite. My code is slow flashing R LED. Earlier today the burners would ingnite and then would go out immediately. Cleared the intake valve from snow. Started up. It was a different code then. Now the glowing yellow light through the peep hole will not even start and we have no burner ingnition. Any ideas?

Check out some similar questions!

Lennox G51MP Furnace goes out after an hour [ 1 Answers ]

My 7 year old Lennox G51 furnace has an intermittent failure where if it runs for more than 1 hour continuously the flames go out, it begins blowing cold air and the status LEDs indicate that it has entered a Watchguard state. This failure is repeatable and always happens after 1 hour. When I...

LENNOX Gas Furnace-High Efficiency G51MP Series NO HOT AIR [ 9 Answers ]

My LENNOX Gas Furnace-High Efficiency G51MP Series is 2 years old. The furnace used to work perfectly. 4 Days ago I started having a problem with it. We woke up in the middle of the night and the house is very cold. The thermostat is set to 72°F and it was reading 66°F. The furnace was running but...

Lennox g51mp furnace warranty information [ 1 Answers ]

I have a Lennox g51 furnace and need to know the term of the warranty. Are there any circumstances where I would be issued a warranty of shorter duration than what the manufacturer authorizes? I have three of these that are 3-4 years old. I have been told by the selling/servicing dealer that my...

Lennox G51MP is not maintaining heat cycle. DS1: off DS2: flashing green [ 0 Answers ]

To be clear, the furnace maintains the heating cycle until the target temperature is reached. Once it kicks off, it stays off until I go to the basement to reset it. It will not come on automatically once the temperature falls below the target setting. With these cold temperatures and a target...

Lennox Furnace Burners Shutting off [ 3 Answers ]

I have a 4 yr old Lennox G51MP Furnace I bought used at a Habitat for Humanity ReStore. It is about 4 years old, and I've hooked it up and it runs fine, the problem is that after about 20 minutes of heat, the burners shut off, and don't re-light. The fan keeps blowing, and the two green flashing...

View more questions Search

Check out some similar questions!

Add your answer here.