 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Trane XE 80 blower runs constantly after room reaches temperature.
Starts up and runs fine until the room reaches set temperature, flame shuts off but fan continues to run blowing cold air through the house. The unit flashes 5 times indicating: flame detected when no fame should be present. Any ideas? I checked temperature limit switches and cleaned the flame sensor but still no luck. Tried to search the forum but could not find an appropriate solution.
|
||||
Check out some similar questions!
I have a Trane XB1000 unit and the fan has been contstantly running even though the heat and ac have not been on and it's about 40 degrees outside. I just replaced the capacitor by the way. Any thoughts on why it is running all the time?
I have a Bryant 394 HAD with a fan that runs constantly. The thermostat is in the "auto " mode, and the burner shuts off properly to the thermostat setting. How do I correct this?
I just had my Trane xl16i air conditioner unit replaced after being installed one year ago. It was leaking refrigerant and had to be recharged every other month so the dealer replaced the unit under warranty. The new unit cools perfectly but the problem now is that the high speed fan continues to...
I have an older heat pump and a/c unit usually works fine today we realized that the blower motor does not shut off.I even turned the thermostat to off but it still runs. Can anyone give me any ideas?Also smelled a little burnt electrical smell when we noticed the blower was not shutting off.
I recently purchased a home with a Goodman furnace and had no idea if the furnace worked or not. The thermostat had the wires from the wall cut with no thermostat, so I replaced it. I'm not sure if the thermostat is wired properly... The wires coming from the wall contain 2 wires, red and white....
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
