Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Peerless purefire problems
[ 6 Answers ]
I just read your post about your peerless boilers. Unfortunately I am having problems after only one year. I have the Peerless Purefire 110 gas fire. The unit will not reach set point temp and continually goes through "trial for ignition" cycles. After pulling the side cover off I noticed all the...
Peerless faucet
[ 0 Answers ]
I have installed a new peerless kitchen faucet model P99355. It is a two handle faucet with a sprayer. After install I turned it on and it worked well for about 2 minutes then started to sputter causing the pipes to bang loudly. Short of buying a new $150 faucet what advise do you give for this...
Peerless Purefire
[ 6 Answers ]
I have a Peerless Purefire boiler (80,000 BTU). The hoses (#1 in picture) that connect from the "combustion chamber" and "vent system", to the tank, leak. I have tried tightening the plastic clamps that come with the boiler, and even used metal hoes clamps, but nothing has worked. Is there a...
Peerless faucet
[ 1 Answers ]
We have a two handled peerless kitchen faucet with sprayer. Water just trickles out and nothing come out of the sprayer. When it is turned on it spits out a little water then there's a clunking noise like when the spayer is used, then after a pause the water flows slow, very slow (2-3 minutes to...
Peerless Diverter Valve
[ 3 Answers ]
Is there anyplace on the web that would have an internal drawing of a Peerless single-lever faucer? My diverter valve is sticking, and before I take it apart, I'd like to know what to expect inside. Thanks Jim View more questions Search
|