Ask Experts Questions for FREE Help !
Ask
    ITstudent2006's Avatar
    ITstudent2006 Posts: 2,243, Reputation: 329
    Networking Expert
    		  
    #1

    Nov 20, 2010, 08:24 PM
    Netgear FSM7328s switch displaying an error I can't pinpoint
    Ok it's a Netgear switch and its at our DR location, it has our SAN and our ARCA Vault appliance running from it. The switch started not working is now displaying the following error on reboot:

    Kernel Panic. Attempting to kill init.

    Any ideas? It's running Firmware version 7.3
    Curlyben's Avatar
    Curlyben Posts: 18,514, Reputation: 1860
    BossMan
    		  
    #2

    Nov 21, 2010, 12:17 AM
    Blimey, very not good.
    Basically the firmware has become corrupt and cannot start.
    I hope you have a back up unit.

    Time for a firmware reload, details here: FSM7328S, FSM7328PS, FSM7352S, and FSM7352PS Firmware Version 7.3.1.7
    ITstudent2006's Avatar
    ITstudent2006 Posts: 2,243, Reputation: 329
    Networking Expert
    		  
    #3

    Nov 21, 2010, 01:40 PM

    I figured it was a FW issue.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ameristar Funace pressure switch error [ 0 Answers ]

The pressure switch error just came on on my Ameristar Furnace this morning. I'm unemployed and have to fix it on my own if possible. What are something I can do to remedy this?

Comfortmaker open rollout switch error [ 1 Answers ]

I have a comformaker furnace and the heat will run for roughly 5 minutes and then shuts off with blower still running. I noticed the duct going up from the main unit is extremely hot (not sure if this is normal), but the light unit blinks 5 times which says "open rollout swith error"? What does...

Trane XL90 Pressure Switch Error [ 1 Answers ]

I tried to start up my furnace this weekend and I got 1 click and then a 2nd click and the error code for pressure switch. I need to know what my next step is to disgnose the problem and get it running since the temps are dropping to just above freezing at night now. I had the blower motor...

Goodman GMNT main switch error [ 2 Answers ]

It's Easter morning... and it's colder than Christmas morning... and my 5-year new Goodman GMNT furnace is not working. Getting 4 blink code, main / auxiliary switch error. I have turned unit on and off and have it working, however when it shuts down and I think the blower continues to run causing...

View more questions Search