 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Testing voltage on gas furnace?
I have a Bryant Plus 80 furnace. Sometimes the HSI glows red before the gas turns on and sometimes it does not. One time I actually saw the HSI glow red then stop glowing red and start glowing red again within a matter of seconds 2-3 seconds at most. Does this mean I have a voltage problem in the control board?
|
||||
Check out some similar questions!
I have a Lennox G20Q3E-75-1 furnace. The ignitor lights the pilot light but not the burner. The ignitor never shuts off. The fan blower will come on after about a minute or so but the burner never lignts. Any ideas??
I was checking voltage at the gas valve on a coleman furnace and my reading was 18 volts. What would cause the drop in voltage? I do have 24v into the board.
My gas furnace doesn't fire-up although I hear clicking inside every time I attempt to toggle the switch bypassing the thermostat. Is it SAFE to short the LIMIT SWITCH to check it that's the problem. Because I remember the furnace was left for several hours running and then all of a sudden it just...
My son has chosen a science fair project wanting to test the affect of water containing different substances (tap, salt, baking soda, etc) on voltage output. I'm too ignorant on elctrical current flows (other than water and electricity don't play well together) to advise him. Can anyone give me...
OK, I need all the help I can get on this one. Please see attached picture. Let me keep it simple. I'm installing a new circuit for 2 new ceiling fans in my house. I ran 12-2 from a new 20 Amp breaker into the ceiling where the first fan will be. From the ceiling box, I ran 12-3 down to...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
