 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Carrier furnace gas valve?
Have a carrier 58RAV. It was just running the blower constantly, per troubleshooting I replaced the board. Now everything runs during the test cycle but when after hot start ignitor glows and my volt meter starts to read volts going to the gas valve I hear a click and the hot surface ignitor and power to gas valve both shut off, then it all starts over again.
Not getting any flash code on the system light. Tried taping the gas valve. Any ideas? Is there something other than the gas valve that could be causing the system to abort or shut down like that? |
||||
Check out some similar questions!
I have a carrier 8000 weather maker furnace and I was told I need a new gas valve. What should I expect to pay for that part.
I have a carrier weathermaker downdraft heat&ac unit that fails to open the gas valve soon enough after the ignitor is glowing before it cycles through another attempt or "locks out". With the inducer motor running and ignitor glowing good either nothing else happens or a hissing noise like a...
We have a Carrier Weather Maker 8000 Natural Gas Furnace not functioning properly. We have replaced pressure switch, hot surface ignitor, flame sensor and control board. It will cycle 3 to 4 times and then not come back on. Is it possibly a bad coil on gas valve?:rolleyes:
Hello, My carrier furnace is on the fritz. I am receiving a 34 code which states"ignition proving failure" The blower fan starts and the hot surface ignitor lights but no gas flows. I replaced the ignitor with a new one-no help. The flame sensor is clean.When I check voltage at the gas valve...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
