Ask Experts Questions for FREE Help !
Ask
    zz's Avatar
    zz Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 27, 2010, 02:53 PM
    Gas valve replacement carrier furnace
    I have a carrier 8000 weather maker furnace and I was told I need a new gas valve. What should I expect to pay for that part.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Feb 27, 2010, 03:02 PM
    Off a dealer it will probably be 200.00 to 250.00 but that is with there markup. Then you also have the labor.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier furnace gas valve opens too late [ 7 Answers ]

I have a carrier weathermaker downdraft heat&ac unit that fails to open the gas valve soon enough after the ignitor is glowing before it cycles through another attempt or "locks out". With the inducer motor running and ignitor glowing good either nothing else happens or a hissing noise like a...

Gas valve replacement for old Sears wall furnace [ 1 Answers ]

I have a Sears LP gas fired forced air wall furnace. I recently had it cleaned and was told that the gas valve was leaking and needed to be replaced. The model is 867.736374. It is over 30 years old. Looking up the part on Sears indicated that it is no long made. Does anyone know who actually makes...

Carrier Natural Gas Furnace main gas valve will not open every call for heat [ 1 Answers ]

We have a Carrier Weather Maker 8000 Natural Gas Furnace not functioning properly. We have replaced pressure switch, hot surface ignitor, flame sensor and control board. It will cycle 3 to 4 times and then not come back on. Is it possibly a bad coil on gas valve?:rolleyes:

Carrier furnace gas valve won't open [ 8 Answers ]

Hello, My carrier furnace is on the fritz. I am receiving a 34 code which states"ignition proving failure" The blower fan starts and the hot surface ignitor lights but no gas flows. I replaced the ignitor with a new one-no help. The flame sensor is clean.When I check voltage at the gas valve...

Replacement of a gas valve in a goodman furnace [ 1 Answers ]

I am replacing a valve in a 10 year old goodman furnace. The old valve has an orange lead in going to the "m" terminal and blue and green leads going to the "c" terminalfor a total of three leads . The new valve only has two terminals . How can I connect the new valve thomdunkneedshelp

View more questions Search