Ask Experts Questions for FREE Help !
Ask
    DerrickPass's Avatar
    DerrickPass Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 10, 2010, 12:27 PM
    I installed a S9200U1000 furnace control on my york.both blower coming on no ignition
    I installed a S9200U1000 Furnace control on my york furnace.My induced blower and circulator blower are coming on at same time and my H.S.I is not igniting.I checked my limit switch and rollout switches,both are working. What could be the problem
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Nov 10, 2010, 07:19 PM

    Dip switch is set wrong, not the right control, or pressure switch did not open. Could all cause your problem. Was it a exact match, or did you have to change some wireing?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier furnace: limit switch fault furnace has ignition but blower will not come on? [ 2 Answers ]

Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?

What is the control on a york furnace [ 1 Answers ]

York diamond 80 furnace fan not coming on [ 2 Answers ]

Fan doesn't come on, in auto or manual, when look at indiactor light, is always off, unless I flick the safety swtich, than it flASHES ONCE & goes off again!

York 80 Furnace ignition goes off when blower comes on [ 12 Answers ]

I have a York Diamond 80 furnace Model# P4HUAR12N03201A. New construction 05 installation. Went away from this house for 2 months. Came back and furnace won't operate. System ignites, heats up plenum, blower comes on, and then the fire immediately goes out. Has a component failed or has the 2...

Installed a new blower in furnace [ 5 Answers ]

I have installed a new blower motor and the motor blows to fast and cuts off three to four times a cycle. Any help?

View more questions Search