Ask Experts Questions for FREE Help !
Ask
    TERRYRYAN's Avatar
    TERRYRYAN Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 6, 2010, 09:42 AM
    York will not start properly I use the restart button to off on and it will fire up
    MONEY2121MIKE's Avatar
    MONEY2121MIKE Posts: 2, Reputation: 1
    New Member
     
    #2

    Nov 12, 2010, 06:15 PM
    I work in apt industry. I came ac ross a loft unit with two thermistats, one downstairs that just controls the temp, and the other controls everything else. We dropped the hatch upstairs and it had two relays hooked up their was wires from both thermistats running to both of them. If you know anything about apts i would love to know how this should be hooked up so we get air and heat we have red and white from condinser, brown white green blue yellow red and orange on each thermistat wire please tell me how its supposed to function or if we can control evrything with one thermistat oh yea and it has a switch that says summer and winter

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

My ge dryer won't start just a buzzing noise when I turn the start button [ 3 Answers ]

It was working fine, just switched the loads and now just a buzzing noise when I turn the start button

Sears Kenmore Dishwasher start button won't start unit [ 0 Answers ]

I have a Kenmore Ultra Wash dishwasher that will not start when pushing the start pad location. It will pump when put on the Cancel/Drain button, but will not start after that. It does have power, or the pump would not run during the Cancel/Drain cycle. The washer was purchased in Jan 20, 2006...

York P3HUD20N10401C not properly cycling [ 10 Answers ]

York furnace would not maintain burner flame. When performing initial trouble shooting removed fan compartment panel disengaging safety switch. Cleaned flame sensor and furnace maintained flame for 4 days of cycling. Last night the fan compartment panel fell open... didn't get properly 'hooked'...

York 90+ won't fire [ 17 Answers ]

Have a york 90+ upflow 100,000btu natural gas unit, won't fire unless I pull the tube from the combustion motor leading to the pressure sensor and put a vacume on it then it will fire and cycle, any suggestions ?


View more questions Search