 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Transformer fuse popping on my heatpump
I switched over from ac to heat on the therostat and heat came on for a bit then popped the fuse on transformer, I reset the fuse and reprogramed the thermostat and tried again. Unit cane on for a few minutes then popped again, I can hear a slight humming coming from the transformer don't know if that is normal or not.
|
||||
Check out some similar questions!
The transformer in the ac air handler keeps huming then it pops where it burned out why?
I have a Carrier - Bryant Heat Pump Heating/Cooling System. A week back, the 5A fuse popped. I replaced it and noticed it pops when there is a need for AUX to come ON. So when the thermostat stat is set to 70 and the room temp is 65 the fuse pops (Typically during cold mornings). When the room...
I have a Goodman Furnace/Ac System. The AC was running fine when I left for work, but when I came home house was very hot. The furnace was flashing 6 lights, which according to the manuel it is the roll out limit. Only problem is that the ac systemis electric, heating is gas fired. Manuel said it...
Hi My thermostat was accidentally knocked-off the wall--it didn't work and so I purchased a new thermostat (a simple digital thermostat, non-programmable). This too did not work. It's a 2-wire system hooked-up to a simple Rh/W config. It was set on Heat and Fan "On" and at a normal 70 F....
While I was replacing old Honeywell 7day programmable thermostat with new Ritetemp touch-screen programmable thermostat, something went wrong and now I have no fan nor heat. The phone support at ritetemp suggested that I must have blown fuse of the transformer. I have 12yrs old York Heatpump...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
