Ask Experts Questions for FREE Help !
Ask
    PMack32's Avatar
    PMack32 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 29, 2010, 04:44 PM
    I have disassembled the handle and cannot lift the spout from the base?
    I have disassembled the handle and cannot lift the spout from the base? Do I need to disconnect anything from the bottom of the sink?
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #2

    Oct 30, 2010, 10:41 AM

    Did you remove all the parts securing the spout? (see image) Good luck, Tom
    Attached Images
     
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Hot to lift my base 6 to a 7 [ 16 Answers ]

My hair is a base 6 and I would like to lift to a 7. Can I lift usinga level 7 colour with a 20 or 30% vol?

Microwave does not turn on unless you lift the door handle [ 0 Answers ]

Whirlpool microwave model mh6700xm-2, it appears the switch inside the unit needs adjusted some how? It operates for awhile if you lift the closed door handle.

How to replace a 2-handle plus spout shower fixture? [ 2 Answers ]

I have a shower that has a two handle, left-hot, right-cold with the tub spout and shower pull up knob in the middle. It needs to be replaced. Do I have to put a hole in the wall to replace it or can it be replaced by dis-assembly in the front?

Leaky Tub Spout With One-Ball Handle Control [ 2 Answers ]

I have two tubs with Delta one-ball handle controls. Both of them leak out of the spout. When the showers are running the tub spouts stop leaking. I found some sites that describe how to remove and repair the washers etc on the Handle, but is a spout drip caused by problems in the handle...

Older Kohler leaking at base of Kitchen Spout. Got off but can't get apart [ 2 Answers ]

I've got a 15 year old Kohler 2 handle kitchen sink that's leaking around spout base. I took the spout off and there's a valve looking thing loose up in the handle. It appears that it once screwed into the base of the faucet assy (the water pressure has always been bad at this sink). It looks...

View more questions Search