Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Removing handle from a Moen single-handle shower
[ 5 Answers ]
The shower is dripping and I am trying to get to the stem by removing the handle. I can see a set screw recessed into the bottom of the handle. I have tried an allen wrench but bent it without any success.
How to replace an old tub spout to add shower
[ 2 Answers ]
I have an old tub/tub spout that I would like to add a tub spout with a diverter so that I can add a handheld shower. The spout has a front end connections. Do they sell a kit that has a shower (not handheld) but connects to spout that will fit my connections? I did see one for a rear connector?...
Need to replace broken shower faucet handle
[ 2 Answers ]
I have a 2 handle shower faucet system. The hot water handle recently broke off just leaving the metal shaft with a phillips head screw at its end. If I turn this screw counterclock wise to remove it, the hot water turns on. What is my procedure to remove and replace this handle with a new one? ...
Leaky Tub Spout With One-Ball Handle Control
[ 2 Answers ]
I have two tubs with Delta one-ball handle controls. Both of them leak out of the spout. When the showers are running the tub spouts stop leaking. I found some sites that describe how to remove and repair the washers etc on the Handle, but is a spout drip caused by problems in the handle...
Replace light fixture
[ 2 Answers ]
I am replacing a light fixture and am confused at all the wiring here. I have two red wires connected to ea other and two black wires connected to ea other. Besides that I have two white wires that were used to connect my old fixture which had two clear plastic covered copper wires. My new light... View more questions Search
|