Trane XE 80, flame "pulsing" and clicking.

dkragen Posts: 1, Reputation: 1

New Member

Oct 20, 2010, 04:09 PM

Trane XE 80, flame "pulsing" and clicking.

I have a trane xe 80. When I start it, it ignites fine, but after about 2-3 minutes, it starts clicking and the flames 'pulse', as if the there is a motor that is feeding gas not running properly. Any advice?

Check out some similar questions!

Trane XL80 Can't Maintain Flame [ 4 Answers ]

I have a Trane XL80 furnace. Basically, when it receives a call for heat, it ignites but cannot maintain the flame. As soon as the flame ignites (or within 10 seconds), it cuts off the gas flow and starts the ignition process again. It does this until the furnace locks out. Sometimes (probably 10%...

Trane xe 90 flame sensor or what [ 3 Answers ]

I just moved in and furnace ignites for about 15 seconds then goes out. I've researched everything I can. Even found the orange wire for the press. Switch had "fallen" off and thought it might have been the whole problem, but still the same thing. From what I found so far I believe it has to be...

Trane flame sensor [ 13 Answers ]

Thermostat call for heat. Ignitor fire and almost at the same moment the pilot flame lights. After a second or two it goes out. Where should I start? Thanks

Gas Flame Pulsing [ 2 Answers ]

I have a unique situation, and have picked the brains of quite a few people, to no avail. I have a Rheem Criterion gas furnace. Here is what happens: Draft inducer initiates Igniter (electric) lights up Gas is fed through a minute later All 4 burners light up simultaneously (for the most...

Trane xe 90 flame sensor or what (again) [ 1 Answers ]

I took the advice from many and cleaned the flame sensor. The furnace ran for about two minutes this time with the burners going, then they went out and continues to be that way. Could it be something else too, or is it likely just the sensor needs to be replaced ?

View more questions Search

Check out some similar questions!

Add your answer here.