Ask Experts Questions for FREE Help !
Ask
    ludylou's Avatar
    ludylou Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Oct 4, 2010, 11:52 AM
    How long before I can lay a laminate floor on a new cement floor?
    Am building a new extension and I want to put a 12mm laminate floor on it. My question is how long will I need to wait to allow the cement floor to dry out and how will I know the cement floor is dry enough to proceed to lay the laminate on it
    Any advise would be appreciated!
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Oct 4, 2010, 07:10 PM
    I will assume this is a slab floor and you will be doing the framing, siding and roofing too. By the time you get the extension dried in and finished, it should be ready for the floor. You will do the floor last and that will be at least a couple of weeks. Just to be sure, run the HVAC for a couple of days.
    ludylou's Avatar
    ludylou Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Oct 5, 2010, 12:45 PM

    Appreciate the reply
    ludylou's Avatar
    ludylou Posts: 3, Reputation: 1
    New Member
    		  
    #4

    Oct 5, 2010, 12:50 PM

    A friend recommended a month an inch to dry out the moisture in the floor as it should read less than 4% before laying newlaminate floor. That means waiting till Jan 2011 before I can proceed - Can I speed up the process?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #5

    Oct 5, 2010, 01:52 PM
    Comment on ludylou's post
    Yes, heat up the room with a space heater. 4 months sounds pretty long, are you going to have a sound deadener under the laminate? That would probably act as a vapor barrier to a degree.
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #6

    Oct 5, 2010, 07:00 PM

    To be honest I don't know how long it will take for the concrete to dry enough to safely cover it with laminated flooring.

    Here is what I think I would do.

    Purchase a couple boxes of the flooring you intend to use. Immediately lay the flooring out on the concrete in a rectangle, just like you would if installing.
    Measure the width, write down the measurement.

    Measure again in two or three days. The second measurement should be greater than the first.

    When it shrinks back to its original measurement all the moisture in the concrete will have evaporated and it should be safe to install the flooring.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Last row of laminate floor does not lay flat [ 6 Answers ]

We can not get the last row (2.5 inches wide) to lay flat. The piece does not snap in. We are using a Shaw laminate that is approx. 7.5 in wide and 47.5 in long. We have tried using a mallet and bar to no avail. Is there a trick that we are not using? Should we trim off the bottom part that...

What kind of adhesive to lay marble tiles in the bathroom floor and wall? [ 1 Answers ]

We want to put 12 x 12 marble tile on our bathroom floor and walls?

How to lay porcelain tile on floor [ 2 Answers ]

Hello, I read a post on here from a member that goes by bljack and it was a great comment. Yesterday I had a handy man quote me on laying porcelain tile and he told me that the best method was to use metal lath with thinset. However another contractor told me that they would use concrete board...

Floor transition on cement floor [ 2 Answers ]

I am laying laminate flooring on a cement slab and need to know what to use since I can't nail A transition strip into the cement.

View more questions Search