Ask Experts Questions for FREE Help !
Ask
    khurupt's Avatar
    khurupt Posts: 1, Reputation: 1
    New Member
     
    #1

    Sep 24, 2010, 01:34 AM
    Bryant Furnace - Code 13 on the circuit board
    Hello,

    I have a Bryant furnace. It keeps flashing code 13 on the circuit board. I read the code and it says that the switch will reset after 3 hours. It also refers me to # 33 which gives more possibilities as to what the problem may be. However it does say to reset the limit or flame roll out switch manually or replace the fuse link. I also took the ignitor and had it tested and it checks out OK. I also replaced the filter.

    I would like to know how to manually reset the limit or flame roll out switch.

    Thank you.

Check out some similar questions!

Carrier/Bryant Furnace control board . [ 9 Answers ]

I replaced Carrier/Bryant board and the led is flashing rapidly.. what can be wrong? It looked like there's problem with polarity,but everything is fine, the led is still flashing.. uff.. Led Code: Continuous on rapid flashing-Line voltage 115 polarity reversed.If twinned,refer to twinnig kit...

Bryant furnace code 24 [ 2 Answers ]

First there was a code 24, Ireplaced the fuse, fan works, but not lighting of the flames to produce heat. Any sugestions as to the next step>

Bryant furnace model 394gaw blew the circuit board [ 1 Answers ]

Bryant furnace model 394gaw blew the circuit board two days ago. I just replace it, but the unit does not turn on? I switched the wires very carefully. What else could have happened? Just a quick question.

I have a bryant 397h furnace and the blower will not shut off.replaced circuit board [ 2 Answers ]

I have a bryant 397h furnace and the blower will not turn off.I replaced the control center circuit board and still runs. Any suggestions?


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.