Check out some similar questions!
Replacement of Carrier Heat Pump Thermostat with Honeywell TH6000 series thermostat.
[ 4 Answers ]
I have a Carrier Series 50QT Electric heat pump that still uses the original non programmable thermostat. I am trying to replace it with Honeywell TH6000 series programmable thermostat. The wiring on the existing Thermostat as follows: O - White, I am thinking this is the Reversing Valve? Y...
Heat pump thermostat using Aux heat
[ 1 Answers ]
I have a heat pump with electric Aux. When outside air temp falls below 35 deg, the compressor almost runs continuously trying to reach set point. The Aux heat wouldn't activate until the room temp falls 2 -3 deg below set point. This scenario makes for rather uncomfortable temp swings I...
Rudd Heat Pump needs Condenser Motor Wired
[ 1 Answers ]
My unit is a Rudd model# UPGB-025JAZ, 208/230 volts year 1997 I believe I have a single pole contactor with a 24 volt coil.. PS thanks for hanging in their with me!
NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue.
[ 11 Answers ]
I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -
Heat pump thermostat Aux. Light is going on when no resistance heat used.
[ 2 Answers ]
I have a Maple Chase SaverStat thermostat on a Lenox heat pump. The thermostat and heat pump are ten years old. Recently when the heat pump comes on the Aux. light on the thermostat also goes on (not the emergency heat light). I have checked and the auxiliary heat strips and they are not heating... View more questions Search
Add your answer here.
|