Ask Experts Questions for FREE Help !
Ask
    iusitino's Avatar
    iusitino Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 30, 2010, 01:04 PM
    How many lihgts to one switch
    I'm trying to wire 120 troffer lights/ 4 bulbs in one light with 4 32watts t8 lamps; how many lamps should go on one circuit; and wire to use; my building is 160' long with wirs running that long;
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
    		  
    #2

    Aug 30, 2010, 04:00 PM

    This is a commercial building? Your electrician should know exactly what to do.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replacing fan motor relay switch with upgraded switch [ 4 Answers ]

Hello, I've searched online to locate a replacement fan motor relay switch for an old Fedders propane heating unit in my greenhouse. The replacement should be fairly easy to do, however the part I was needing ( RBM 84-20103-301A) was listed as obsolete and was replaced by (McQuay part #...

I replaced pull switch lights with recess but the wall switch won't turn off the light [ 2 Answers ]

I added lights and outlets to my basement and all of the outlets work fine. Before I started the switch on the wall controlled one light and all of the others had pull strings. I've tried everything but the switch will not turn off the remaining three lights. What did I do wrong... how do I fix it?...

Separate Fan light switch, fan switch and switch for can lights to one location [ 2 Answers ]

I have A circuit that has 6 can lights and a fan light. The power is at the switch box I need to know how to wire the separate switches for the cans,and the light on the fan, and fan (That would be in a three gang switch box.) to one location.

York residential furnace pressure switch problem code stuck switch [ 1 Answers ]

I have a york furnace P2MD12H06401A after 1 hour it shuts down and gives a 2 flash error for a stuck pressure switch. The switch is new can it be wired wrong? The old one had 2 white wires piggy back and 1 blue wire. The new switch has 3 separate terminals

Connect a port on a remote switch to a secure segment on the local switch [ 4 Answers ]

I have 2 Netvanta 1224R switches. On the main switch I have 3 Vlans setup. Vlan1 = main network (example IP 123.231.5.1) Vlan2 = Web Access (Example IP 69.115.851.202) Vlan3 = Secure segment (Example IP 123.231.8.1) On the remote switch I have 1 Vlan. Vlan1 = Main network (example IP...

View more questions Search