Ask Experts Questions for FREE Help !
Ask
    meekoh's Avatar
    meekoh Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Aug 23, 2010, 01:02 PM
    How do I take the fan apart so I can get to the blades, they don't show access
    I have a Harbor Breeze 52" ceiling fan, i bought down w/ taking the blades off, because they're in a manner that don't give you access to them, the fan has a dome light , but I can't even take the dome off, how do I do that, the model is #SER52BP5LKRC 52" CEILING FAN, D5201, Please help I can take the blades off/nor the Light Dome
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Aug 23, 2010, 05:37 PM

    Hollow threaded rods are typically used to assemble lights and fans.

    I;m assuming your not talking about the cover against the ceiling.
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
    		  
    #3

    Aug 23, 2010, 05:46 PM

    Searching the model number shows nothing. How about posting a pic so we can see what it is you are dealing with.

    90% of the time on newer fans you have to take the light kit completely off to access the blade bracket screws.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How much ar fan motor blades [ 0 Answers ]

How much ar fan motor blades, mine are stuck on the shaft and having difficulty removing. Used WD-40 on the shaft and left for 2 hours, kept re-spraying the WD40 in between time

Ceiling fan blades catch on casing for light below. Can I adjust blades to raise them [ 1 Answers ]

Hi. I installed my Kendal ceiling fan and light but the blades won't turn on their own. The motor hums and if I turn the blades to get it going they turn, but there is a hideous grinding noise as the blades rub against the light casing below. Is there any way to adjust the blades so it will turn...

Locked fan blades [ 5 Answers ]

I replaced the pull chain for my ceiling fan light. When I got everything wired and ready to go the fan blades were locked. I have checked the pull chain for the fan blades but nothing seems to unlock them. I can hear the motor running for the blades they just won't move. Any ideas?

Ceiling Fan Doesn't Run with Blades on [ 13 Answers ]

The blades on my ceiling fan were loose. When I tightened them, the fan would not turn. I tried loosening them again to their previous position, but no luck. When I remove the blades, the assemble runs at full speed. When the blades are reattached, it does not run or runs very slowly. I have...

Harbor Breeze Fan Blades [ 3 Answers ]

Our Harbour Breeze Fan has 2 pulls, one for the light and one for the fan. When I pull the one for the fan the blades will turn just barely and will not go any faster. How can we correct this?:confused:

View more questions Search