Ask Experts Questions for FREE Help !
Ask
    domwood's Avatar
    domwood Posts: 4, Reputation: 1
    New Member
    		  
    #1

    May 23, 2010, 10:14 AM
    How much ar fan motor blades
    How much ar fan motor blades, mine are stuck on the shaft and having difficulty removing. Used WD-40 on the shaft and left for 2 hours, kept re-spraying the WD40 in between time

Check out some similar questions!

How to remove Fan Blades from Compressor Motor [ 4 Answers ]

The bearings in the fan motor attached to my HVAC compressor appear to have gone out (there was a squealing sound before the motor stopped working and the fan blades are hard to turn by hand). We want to replace the motor but haven't been able to find any guidance on how to remove the fan blades. ...

Engage Blades motor conks out and backfires [ 1 Answers ]

Please help! I have a Craftsman Lawn Tractor 17HP Kohler Engine and I bought it in 2003 so its fairly new. When I start it up with the choke and then let it idle it seems to run OK, I can even drive it around a bit. However when I engage the mower blades to cut the grass the rpm seem to...

Ceiling fan blades catch on casing for light below. Can I adjust blades to raise them [ 1 Answers ]

Hi. I installed my Kendal ceiling fan and light but the blades won't turn on their own. The motor hums and if I turn the blades to get it going they turn, but there is a hideous grinding noise as the blades rub against the light casing below. Is there any way to adjust the blades so it will turn...

John Deere stx38 motor sputtering after blades catching and throwing sparks [ 1 Answers ]

I have a John Deere Stx38, and as stated I seem to have a problem with my motor. I just started to mow my yard, and a piece attached near where the grass is thrown was bent in and caught my blade (throwing sparks like crazy) I disengaged my blades and turned the mower off and now my mower engine...

Craftsman mower will not start after blades quit turning and motor was turned off. [ 1 Answers ]

I have a craftsman dyt 4000 lawn mower. I was mowing and the blades quit turning. So I turned the motor off to check the belts and now it won't start, not even a click when key is turned on.

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.