 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Most 230 Volt Pool Motors will have just three connections. One hot wire to L1, the other to L2, and the green wire goes to the ground connection. These will usually be both black or both red wires, or sometimes one black and one red. There is no common wire on a 230v pump unless perhaps it is a 2-speed. The bare copper wire connects outside the wiring compartment to the frame of the motor and is called a bond or bonding wire. Hope this helps. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
480/277 volt 3 phase power is the proposed electrical service for a for a new building. Will I be able to power machinery that requires 230 volt 3 phase?
Can you supply wiring diagram for a 240 volt timer for swimming pool pump. The wire from the pump (240 volt) one black, one white and one green. I assume both the black and whit are load and should be connected to the two load terminals on the timer. Is this correct?
Hello, I am rewiring switched for two pool pumps. The old set disintegrated so I cannot tell how they were wired. The two pumps are recirc and booster and are both 230v. I would like to wire them so that the booster can only turn on when the first pump is on. How can I manage that wiring with no...
I bought a beautiful chandelier at a garage sale at a great price. Can the chandelier be wired for 230 volts for use in the Philippines as long as 230 volt bubs are used?
I have a 6 hp 230 volt air compressor motor that I have wired on a twin 20 amp breaker with a 10/2 wire. I cannot get the motor to start, I have took it off and had it checked and it works fine, just not when I wire it up in my garage. I do have power at my 10/2 wire, and cannot understand why it...
View more questions Search
|
