Ask Experts Questions for FREE Help !
Ask
    cortez61's Avatar
    cortez61 Posts: 3, Reputation: 1
    New Member
     
    #1

    Jul 20, 2010, 12:48 PM
    Low water preasure from hotwater tank
    All taps in house have no water preasure on hot side but lots on cold can this be fixed?
    cortez61's Avatar
    cortez61 Posts: 3, Reputation: 1
    New Member
     
    #2

    Jul 20, 2010, 12:50 PM

    I have no hotwater preasure at any tap in house but cold is fine, how can I fix?
    cortez61's Avatar
    cortez61 Posts: 3, Reputation: 1
    New Member
     
    #3

    Jul 20, 2010, 12:53 PM

    I have no hotwater preasure at any tap in house but cold is fine, how can I fix?
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #4

    Jul 20, 2010, 02:57 PM

    This is a common problem in my area. Usually the dielectric unions on top of the water heater get plugged up and changing them is what I do. However, it may be a clog in the shut off valve, or shut off isn't turned all the way on, or there may be galv nipples on top of the water heater that have plugged. I would start by shuttting water off to heater, and disconnect dielectrics to see if they are plugged.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Low water preasure in kitchen [ 1 Answers ]

We replaced the water line in kitchen. It was leaking; Now there is far more less preasure. The water preasure is so low I cannot use the sprayer

Low hot water preasure from faucets [ 1 Answers ]

How can I get the hot water preasure to build up. So I take a real shower

Low water preasure [ 1 Answers ]

I have two bathroom side by side on my second floor. One shower has good water preasure but the other trickles out. Can this be fixed? Thanks, Rob

Changed valve on Hotwater tank leads to low flow [ 1 Answers ]

I have a 40 Gallon Natural GAZ "GIANT" hot water tank. The Cold water in valve was leaking so I changed the piece. I made sure that the everything was clear and clean and that the valve was a BI-Directional flow. The tubes are PEC and I crimped the O-rings into place and they are a GO. ...

Hot water tank how do I turn it on for my hotwater [ 5 Answers ]

I have not had hot water for 3 days I need a shower, asap , how do I light my pilot where is it I have a gas hot water tank it has a switch that says on,off,and pilot and in the instructions it says to light pilot and hold for 1 min but do I use a lighter or what where is the pilot and how do I...


View more questions Search