Ask Experts Questions for FREE Help !
Ask
    sammisgram's Avatar
    sammisgram Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 2, 2010, 10:49 AM
    Washer doesn't spin
    Whirlpool modelGSQ9364HQO doesn't spin. I can hear the motor running it isn't spinning. The motor stops when I open the door. Any ideas would be appreciated.
    twinkiedooter's Avatar
    twinkiedooter Posts: 12,172, Reputation: 1054
    Uber Member
    		  
    #2

    Jul 3, 2010, 05:17 PM

    It might be the lid safety switch that needs replaced. Try that.
    shulta44's Avatar
    shulta44 Posts: 97, Reputation: 4
    Junior Member
    		  
    #3

    Jul 4, 2010, 08:04 AM

    Your washer should be a direct drive. If the motor is working I would check the motor coupling. It goes between the motor and the transmission. It is made of rubber and will break (about $15.00) to replace. You will find ground rubber under the washer. Check that.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Whirlpool washer, agitator works, but during the spin cycle it doesn't spin [ 1 Answers ]

I have a whirlpool washer, I replaced the outer tub and the drive block, but it now doesn't spin. It drains the water, I can hear the motor come on, and feel the vibration . The switch is fine. I looked at the couple, but did not take it apart. The clutch looked fine, sanded the pads and case....

Kenmore washer 70 series humming at spin cycle - won't spin [ 4 Answers ]

RE: kenmore 70 series model 110.20712990 Type 111 top load washer. Won't spin. Humming noise and a little burning/hot smell when supposed to be spinning. Bypassing the lid switch did not correct the problem. Changed out the motor coupling with no luck... still a humming noise but no smell.

Washer won't spin [ 2 Answers ]

Hello all, I am new to this site and am glad to have found it. I have an older whirpool top load washer. Today the spin cycle stopped working. Everything else is working properly, but it won't spin. Any ideas? Thanks for any suggestions. Nancy

View more questions Search