Ask Experts Questions for FREE Help !
Ask
    dunningkelly's Avatar
    dunningkelly Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 26, 2010, 07:04 PM
    Walk-behind mower, B&S 650 series engine, 2007 model. How might I get BOTH wheels pulling again?

    Kelly

    Degree of difficulty in fixing the drive component of the front wheels? When I engage the clutch lever, only the right drive wheel is pulling. 2007 model B&S 650 series engine.
    wolverine1012's Avatar
    wolverine1012 Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Jul 28, 2014, 01:24 PM
    Kelly, it may be as simple as replacing the wheel. Using a socket wrench, remove the bolt in the center of the wheel (after removing the hubcap, if you have one). The inside of the wheel is like a plastic gear and the teeth may be worn off. It's easy to check this first.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Craftsman LT 1000 mower model 917-271652 what year sold? [ 3 Answers ]

What year model is our Craftman riding mower, LT 1000, model number 917-271652? Thanks, Joe

Craftsman Lawn Tractor Steering Issue.Left Front Wheel will turn too far [ 14 Answers ]

Model 917.252522 When turning to the right no problem... when turning to the left if too sharp the left front wheel will turn further than the right and cock almost perpendicular to the front to rear centerline of the tractor... This evening I removed the wheel expecting to see a bad bearing...

Craftsman Model 917.253741 Mower [ 2 Answers ]

I am looking for a manual for a 1983 Craftsman Rider Lawn Mower, Model 917.253741, Serial Number 0983501710. I know its old but we just bought an engine for it and it runs like a charm, but I need the manual for a parts list... HELP

Craftsman 11hp ridding mower 917-255371 model [ 1 Answers ]

I have a 11hp craftsman mower 80's model. Engine is in front.the problem is it jerks you back hard ideling low to mid rpm rande in 1st and pulls the wheels off the ground in 2nd gear.belt driving clutch from what I can tell and the pully’s all seem to spin freely.uses one pedal for clutch and brake...

How can I replace the power drive belt in a Craftsman Model Number 917.251492 mower [ 2 Answers ]

My riding mower Power drive belt needs to be repaced and am asking the procedure for this. The belt is attaced to the transaxle and clutch

View more questions Search