Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
New shallow well pump new huge pressure tank but water pressure is terrible
[ 11 Answers ]
When I had a smaller pump (shallow well) and small tank my water pressure was great. When I had to replace everything the person installing the system put a bigger pump and a huge pressure tank. It is the size of a 50 gal water heater. I replaced everything. Ever since then my water pressure is...
Pressure washer pump inop
[ 2 Answers ]
What's the most common problem when the pump quits. I have a Craftsman 6.5 OHV w/horizontal shaft motor. The pump is attached to the output shaft, or the front of the motor. Model 580.767300 I took the pump face off and I can tell you this, the 3 pistons do move in and out, and the piston seals...
Craftsman honda pressure washer pump problem
[ 0 Answers ]
I have a Craftsman pressure washer with a Honda engine. It's about 8 years old. I have never had trouble with it but I just went out to use it and I cannot get water to get through the pump with any pressure, only a very small trickle. It seems the pump must be clogged or something but I can't...
Pump pressure switch does not turn on with low pressure
[ 0 Answers ]
I lost water in my home overnight. The pressure gage reads about 8 PSI. If I use the lever on the pressure switch to close the contacts, nothing happens. Actually, the pump controller box, makes a buzzing sound for a couple of seconds, but that's it. Does anyone have any thoughts? I don't...
What is the correct suction pressure and head pressure for a 3 ton tempstar heat pump
[ 1 Answers ]
When the yellow jacket brand gauges are put on a 3 ton Tempstar heat pump what should the correct suction pressure and head pressure be. I suspect it to be overcharged in freon. Because it is freezing the compressor, accumulator tank and all the lines soild ice. View more questions Search
|