Ask Experts Questions for FREE Help !
Ask
    kstancik's Avatar
    kstancik Posts: 2, Reputation: 1
    New Member
     
    #1

    Jun 17, 2010, 05:27 PM
    Craftsman riding mower dies
    We have a Craftsman riding mower that has suddenly stopped running after about four minutes of mowing. Gas flows through the fuel filter just fine. I read a similar post from 2009 where the final suggestion was "blockage in the fuel inlet above the needle". Any other ideas?
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
     
    #2

    Jun 17, 2010, 08:04 PM

    Does it start ,and what model do you have.
    kstancik's Avatar
    kstancik Posts: 2, Reputation: 1
    New Member
     
    #3

    Jun 17, 2010, 08:59 PM

    Yes, it starts and runs for about 4 minutes then dies. We make a circle around, restart, and it goes again. Model? Don't know but can look it up tomorrow...
    jsfocke's Avatar
    jsfocke Posts: 310, Reputation: 37
    Full Member
     
    #4

    Jun 18, 2010, 09:03 AM

    The first and simplest thing to check is the gas cap. If the little hole in the center is plugged it will run for a while and then stop because no air can get into the tank. Just try running it, not mowing, without the cap on and see if it stops. If not then that is your problem. If it still stops and the gas flows freely after the filter then the problem is more than likely in the carb.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

2005 Huskee riding mower PTO won't engage and mower dies [ 12 Answers ]

Replaced battery with new one, within several starts the new battery was drained. Mower will start by jumping but only runs a few minutes then dies, also the PTO will not engage at all (replaced PTO switch and still won't engage) does not even attempt to engage, as if there is no power to the...

I need a mower deck belt for a Craftsman xls 1000 riding lawn mower. [ 2 Answers ]

I can't find a belt for my Craftsman xls 1000 riding lawnmower deck.

Diagram for replacing lawn mower belt on Sears Craftsman 4000 Riding Mower [ 9 Answers ]

I need a diagram on how to replace a belt on the Sears Craftsman II 4000 riding mower

Craftsman Riding Mower dies when I engage blades [ 2 Answers ]

I just bought a Craftsman 24HP riding mower 2 months ago. Just today when I was mowing the lawn it died in the middle of cutting. After I disengaged the cutting blades, I was able to re-start it. But every time I rotate the engagement lever the engine dies. The belt/pulleys seem to be working...

Mtd riding mower dies [ 1 Answers ]

I have a 15.5 38" mtd riding mower. When I engage the pto to mow, it kills the engine. The under the seat safety is disengaged... is there another one somewhere making the engine die?


View more questions Search