Ask Experts Questions for FREE Help !
Ask
    butch157349's Avatar
    butch157349 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 5, 2010, 06:54 AM
    Peotech replacement motor wiring
    JoeyFedoras asked about the wiring sequence on a Protech 5 lead replacement installation (oct 9, 2009). Did anybody ever answer this? Trying to find myself. Thanks.

    Butch
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Jun 5, 2010, 07:09 AM
    Yes,, it was answered
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replacement Motor Wiring for condenser unit [ 4 Answers ]

I have a Lennox HS16-461V-4P. The motor bearings died and I ordered a replacement motor. The old motor (GE) had two purple wires that went to and from the capacitor mounting in the unit. It also had orange and black wires that went to line voltage. The new motor (Emerson) only has three wires...

Wiring replacement Condenser Fan motor [ 10 Answers ]

I replaced the condenser fan motor on my old Tempstar A/C, but I am a little uncertain about the wiring on the new motor. Attached is a picture of the way I have it wired right now and the wiring diagram that came with the motor. The old motor had 3 wires: Black - wired to T2 contactor ...

Replacement emerson motor wiring different [ 2 Answers ]

I purchased a replacement fan motor for my Lennox AC unit . The old motor had 3 wires -orange , purple and black. The new one, a emerson K55HXSSm-7146 has 4 wires and a ground-black,white,brown and brown w/white. I hooked the brown wire to the dual capacitor "Fan" terminal. The Black to what...

Replacement blower motor wiring [ 1 Answers ]

I purchased a replacemet fan motor for an older rheem heat pump. The wiring is different from the original. There are 2 browns for the capacitor, one green to ground, a black common, and a yellow one labeled "line". Where does the yellow wire connect? The old one had 2 for capacitor and one common.

Replacement furnace motor wiring question [ 2 Answers ]

I am replacing our existing furnace blower motor. The old motor had two speeds; the new one only has one speed. The old motor had 3 wires: black, white, and blue/white spiral. The new motor has two wires, both black but one has a raised ridge that I was told was the neutral or "white" wire. ...

View more questions Search