Ask Experts Questions for FREE Help !
Ask
    netmonster's Avatar
    netmonster Posts: 2, Reputation: 1
    New Member
     
    #1

    May 29, 2010, 09:51 AM
    Honeywell vision pro8000 screen not working
    Hello all,


    My honeywell vision pro8000 touch screen stopped working the other day. My wife said she woke up in the middle of the night and the light on the unit was lit up. The display lights up but I can not change any of the settings. If I leave the unit attached to the wall, the AC will kick on and keep the house cool but I don't know what it's set to.

    Any advice?

    Kris
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #2

    May 29, 2010, 12:38 PM
    Kill the power to furnace at the breaker box,wait a few minutes and then back on, sometimes they need to be reset,, you may then need to reprogram,, let us know

    Sometimes,not very often with a honeywell tstat they just go bad
    netmonster's Avatar
    netmonster Posts: 2, Reputation: 1
    New Member
     
    #3

    May 29, 2010, 01:09 PM
    I did what you suggested and the device did reset, however I can't program it. It's stuck waiting at for me to change the date. I think it broken.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Honeywell vision pro 8000 installation [ 1 Answers ]

I have a Trane Model XR 90 High Efficiency, 100,000 BTU’s to heat a two-floor space with about 1900 square feet. When the outside temp. is around 20 degrees F and I set the thermostat to Hold at 63 degrees during the nighttime, when I get up the thermostat is reading 60 degrees. It cannot keep...

Vision pro 8000 screen comes up as EE, have troubleshooted as said in the manual? [ 4 Answers ]

Ive got a vision pro 8000 thermostat, a few days ago the screen came up as EE I had changed the batteries in the back and got it working again, however I got the same problem yesterday and even though I changed the batteries the sign came up again after a few hours any help?

Switching from robertshaw CM260 to a honeywell vision pro 8000 [ 2 Answers ]

I am switching from a Robert Shaw cm 260 to a Honeywell vision pro 8000 (TH832OU1008 and on my Robert Shaw there is a spot for a white wire that connects to "O" but that is no where on my honeywell? Where does that wire go?

Honeywell Vision Pro 8000 TH8320 wiring [ 8 Answers ]

Hello, I have a 2-stage heat, one stage cool heat pump. I am trying to wire this thermostat but it is not working. I called a professional and she told me to wire it as follows, but the heat will never kick on no matter how long I wait. Left Side Heat Pump Y2-No wire L-No wire E-No wire...

Programming a Honeywell Vision Pro Commercial Thermostat [ 1 Answers ]

Our small community library installed a Honeywell TB8220 Commercial VisionPRO Programmable Thermostat last summer and the installer programmed it with no coaching to the volunteers who try to keep the library going. He is extremely busy plus we are trying hard to avoid the $75 per hour charge. We...


View more questions Search