Ask Experts Questions for FREE Help !
Ask
    Mike53's Avatar
    Mike53 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    May 28, 2010, 05:04 AM
    26 hp Briggs and Stratton 4667
    I have a Briggs and Stratton 26HP model# 4667 engine in my Husqvarna mower.
    A friend and I have found bent rods in the head on the other side of the engine from the fuel intake.
    We have placed two sets so far and bent both of them on the exhaust valve. Later we noticed the sleeve on the exhaust valve has slipped up. We had a machine shop press it back down to where the sleeve was discolored. Not sure that is where it should be set, it sets about 1/8” above the cast head. Is that enough? Any other information you feel is necessary for success please feel free to comment.
    Mike53's Avatar
    Mike53 Posts: 2, Reputation: 1
    New Member
    		  
    #2

    May 28, 2010, 09:48 AM
    Why does Briggs and Stratton charge for information about their crummy engine repair problems?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Briggs and stratton [ 1 Answers ]

Our neighbor has a Riding lawn tractor with a B/S engine... 28N707 type: 0150-01 code: 9409124A. The engine starts pretty good however after only 30 seconds - 1 min. the exhaust pipe becomes "red hot" WHY? In addition to that when he is ready to shut down the mower (idling it down) it backfires...

17 hp briggs and stratton [ 1 Answers ]

What is the gap on a 17 hp ohv adjustment

16.5 hp briggs and stratton [ 2 Answers ]

I have an older 16.5 hp Briggs and Statton riding mower,and have had the starter rebuilt. I was told that before I put it back on the mower I need to have "The Valve" turned or it would be pointless.My question is what valve needs to be turned and where is it located.I am assuming I would takr the...

10 hp briggs and stratton [ 1 Answers ]

I need to know what the intake and exhaust valve setting for a briggs and stratton generator. Thank you :(

View more questions Search