Ask Experts Questions for FREE Help !
Ask
    karmathedog's Avatar
    karmathedog Posts: 2, Reputation: 1
    New Member
     
    #1

    May 24, 2010, 07:13 PM
    Coleman evcon furnace pressure switch failed to close
    My Coleman Evcon furnace will not heat. I took off the cover and saw a red light flash three times indicating pressure switch failed to close. I blew into both ends of the rubber tube. I noticed a click as I blew in the direction of the pressure switch and another click as I ceased blowing. Other than that, I am out of ideas. Thanks.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #2

    May 24, 2010, 07:22 PM
    Make sure the rubber hose doesn`t have any holes or cracks and that it fits tight on both end connections
    karmathedog's Avatar
    karmathedog Posts: 2, Reputation: 1
    New Member
     
    #3

    May 24, 2010, 07:26 PM

    Thanks for responding wmproop. The hose is in good shape and the connections are tight.
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
     
    #4

    May 25, 2010, 05:39 AM

    Take the vent motor out and check for a blockage, birds or dirt.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Evcon Furnace 3 Flashes Combustion Air Switch Failed to Close. How Do I Repair It? [ 2 Answers ]

Evcon Central Furnace fault light flashes 3 times, combustion air switch failed to close, how do I make repairs?

Coleman evcon furnace [ 5 Answers ]

My home has coleman evcon furnace 12 years old.I can set the thermostat at 74 degrees and the furnace will start with a 30second purge then the ignitor will warm up and glow red then the main burner lights.then the burner stays lit and the blower runs for a couple minutes. Then the thermostat calls...

PS failed to close Coleman Evcon Model as36a264t LM [ 10 Answers ]

Coleman Evcon Model as36a264t LM Hi I have the above model forced natural gas furnace. I started getting the three blinking lights indicating the pressure switch failed to close. I am not sure what to do. I removed the rubber hose and mde sure nothing was stuck in it and blew through it (hose...

Coleman Evcon Furnace [ 1 Answers ]

We have a Coleman Evcon DLAS075BDD furnace which keeps displaying error codes: 1-Ignition Failure and 4-Limit cycling. We have replaced the circuit board. Inspected the ignitor and the flame sensor and both appear good. Also have taken the exhaust vent/hood off and vaccuumed out any rust to...

Coleman evcon furnace [ 1 Answers ]

I have a coleman evcon direct vent forced air furnace, the air is blowing cool air, everythinig else is working it's firing ,the fan is working


View more questions Search