 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
14.hp briggs that has a carb fuel problem
I put a used engine in my tractor the old engine had a celoniod on the bottom of carb and the used one did not , the engine runs but it runs like its choked out , I bought a new carb #492915 and installed it , to the same resolts, if I crimp off the fuel line it runs great and then runs out. It used to have a fuel pump but the used engine is gravity feed , so I by passed that and the celeniod . How to adjust carb or is this getting too much gas please help my grass is out of control, thaks JIM R
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have an old Murray riding motor that won't run for more than a minute or two. If I clean the plug, I can get it to start fairly easy but will start to sputter and finally stop after a minute or two. I took the carb off and made sure the float wasn't stuck -- it appeared fine. Running the mower...
16 H P Briggs carb will not take gas without squirting into top. Gas IS getting to carb. Wire is hot to anti backfire/fuel shutoff solenoid but it does not click. I'm told it's bad. How do you remove it. I see no threads or how to remove it. Thanks Buddy
I recently obtained a briggs and stratton 20hp riding mower that won't run. Free of course. The original owner said it quit running one day while cutting the yard. I took the carb apart and cleaned it. It was reinstalled and an attempt was made to crank it. When it did not crank, I squirted gas in...
View more questions Search
|
