Ask Experts Questions for FREE Help !
Ask
    Buddy B's Avatar
    Buddy B Posts: 6, Reputation: 1
    New Member
    		  
    #1

    Feb 12, 2007, 07:33 PM
    16 H P Briggs carb takes no fuel
    16 H P Briggs carb will not take gas without squirting into top. Gas IS getting to carb. Wire is hot to anti backfire/fuel shutoff solenoid but it does not click. I'm told it's bad. How do you remove it. I see no threads or how to remove it. Thanks Buddy
    newaukumdon's Avatar
    newaukumdon Posts: 525, Reputation: 44
    Senior Member
    		  
    #2

    Feb 13, 2007, 05:22 PM
    On the honda there are two small screws up through a flange, I do not recall how the briggs mounts.
    Don
    Buddy B's Avatar
    Buddy B Posts: 6, Reputation: 1
    New Member
    		  
    #3

    Feb 13, 2007, 06:54 PM
    :)
    Quote Originally Posted by newaukumdon
    On the honda there are two small screws up through a flange, I do not recall how the briggs mounts.
    Don
    Don, Thanks for the input, but my Briggs is not like that. Bubby
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Briggs&Stratton Pulsa Jet Carb problems [ 9 Answers ]

I'm having trouble starting an older aerator with a B&S 3.5hp horizontal shaft engine with a Pulsa Jet carb. I've changed diaphragm, and carb-to-fuel tank gasket. It can be started and run on starter fluid, but doesn't seem to pump gas into carburetor. What else to look for?

No fuel in carb bowl [ 3 Answers ]

I recently obtained a briggs and stratton 20hp riding mower that won't run. Free of course. The original owner said it quit running one day while cutting the yard. I took the carb apart and cleaned it. It was reinstalled and an attempt was made to crank it. When it did not crank, I squirted gas in...

19hp briggs new carb and stalls [ 3 Answers ]

Hi all new to the fourum I have a question I hope you all can help. I have a murray lawn tractor with a 19 hp briggs. I put a new carb on it and the tractor runs but stalls under a load like it is running out of fuel. When I inspected the carb the bowl was full of gas and clean. The mechanic I took...

Carb tuning a 12hp Briggs (non-OHV) [ 1 Answers ]

I am a new member who recently purchased a used Montgomery Wards riding mower (serial no.TMC 36937A/K219H). The mower had recently been painted- over red (poorly), so the ser. no. could be slightly off. I am experiencing difficulties in properly tuning the carb (i.e. the governor is kicking in @...

Briggs , no fire or fuel [ 1 Answers ]

No fire or fuel on a 14.5 briggs ohv mtd mower. If I disconect the 2 prong connector at front of mower going to fuel solonoid and coil, I have fire but no fuel.How does the fuel solonoid work and where does it get it's power from? I have no voltage coming from ignition sw to yellow wires at clutch...

View more questions Search