Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
No Trap seal under newly installed basement shower
[ 4 Answers ]
I have a fairly new (3yrs) shower that was put in by an inexperienced "contractor" who apparently did not install a " trap seal" as part of the drainage system, so that we can hear and smell all sewage from the home flowing under this shower(we need to keep the drain covered). What would be...
Is p trap required on washer drain
[ 1 Answers ]
I am adding a laundry room the drain right now goes directly to the main sewer line . Would I need to install a p trap on the washer drain? Thanks.
Calculating slope and change in slope (Mathcad)
[ 2 Answers ]
Hello, I have been using mathcad for a only a few weeks, so my knowledge of it is limited. I have a set of data points which I have created some polynomial and cubic splines on a graph. What I want to do is calculate the slopes and change in slope of the curves. Any help on a mathcad...
Replacing a p-trap in a dap-out once shower is installed?
[ 2 Answers ]
Hello all, It is my understanding after reading several threads on this site that when installing a shower over a slab of concrete you need to leave a hole "Dap-out" about 14x14 so you are able to perform maintenance on the P-Trap if needed. But once the shower is installed over the P-Trap how...
P-trap GAP - p-trap too low to meet sink drain extension
[ 13 Answers ]
I just took an old crane drexel sink off the wall and replaced it for the time being ( I want to fix the older sink) with a cheap vanity/sink set. All that was easy enough, but now to my chagrin I can't finish the job. The p trap is too low, the extension pipe from the sink doesn't go all... View more questions Search
|