Ask Experts Questions for FREE Help !
Ask
    Ricinus's Avatar
    Ricinus Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 6, 2010, 02:22 PM
    Intertherm thermostat anticipator
    Looking at the anticipator brass slider indicator, there is a little pointer on it that points to the range of numbers. Do we use this pointer to set the slider to the numbers, or do we use the bottom edge of the slider to set to the number? I know the nominal setting is 0.4, but I'm not sure about how to read the slider position. Furnace is short cycling.
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    May 6, 2010, 05:41 PM

    Use the pointer.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Heat Anticipator [ 1 Answers ]

Our gas, forced air furnace seems to go on and off too much. The blower goes on for 3 1/2 minutes, then off for 2 minutes, over and over again. Is that normal? I have read the manuals for the furnace and the thermostat. Both say that the heat anticipator on the thermostat should be set at the...

Intertherm thermostat works only in on position and not auto! [ 4 Answers ]

Why does my thermostat only activate my furnace in the on position and not also in the auto position?:confused:

Intertherm thermostat wiring [ 2 Answers ]

I have a intertherm model no. M1MB 056A BW and have bought a hunter thermostat 44360 the intertherm thermostat has a green,red and white wire coming from the back of it and I am not sure where to put them on the hunter thermostat can anyone help me please ?:confused:

Intertherm programmable thermostat [ 1 Answers ]

I have a Intertherm gas furnace with air conditioning. I would like to replace the intertherm thermostat with a programmable one. What one would be compatible with this system? Thank You

Intertherm a\c won't shut off by thermostat [ 8 Answers ]

Need help! I have Intertherm furnace and a\c system model number MGH-100-ABWN-05 while the heat\a\c switch on the furnace is on A\C my thermostat can't control it. I have a electronic thermostat made by ritetemp (model number 8030C). I do have the RC terminal jumpered to the RH (r on the...

View more questions Search